Up: Main Previous: Acknowledgements

References

1

A. Bentur, "Microstructure, interfacial effects, and micromechanics of cementitious composites," in Advances in Cementitious Materials, ed. S. Mindess, Ceram. Trans. 16 (Amer. Ceram. Soc., Westerville, Ohio, 1991), pp. 523-550.

2

X. Ping, J.J. Beaudoin, and R. Brousseau, Flat-aggregate portland cement paste interfaces, I. Electrical conductivity models, Cem. Conc. Res. 21, 515-522 (1991).

3

U. Costa, M. Facoetti, and F. Massazza, Permeability of the cement-aggregate interface: Influence of the type of cement, water/cement ratio and superplasticizer, in Admixtures for Concrete: Improvement of Properties, ed. E. Vazquez (Chapman and Hall, London, 1990), pp. 392-401.

4

R. Zimbelman, A contribution to the problem of cement-aggregate bond, Cem. Conc. Res. 15, 810-808 (1985).

5

R. Uchikawa, Similarities and discrepancies of hardened cement paste, mortar, and concrete from the standpoint of composition and structure, J. Res. Onoda Cem. Co. 40, 1-24 (1988).

6

K.L. Scrivener and E.M. Gartner, Microstructural gradients in cement paste around aggregate particles, in Bonding in Cementitious Composites, ed. S. Mindess and S.P. Shah (Materials Research Society, Pittsburgh, 1988), pp. 77-85.

7

D.P. Bentz and E.J. Garboczi, Digitized direct simulation model of the microstructural development of cement paste, in Physical Phenomena in Granular Materials, ed. G.D. Cody, T.H. Geballe, and P. Sheng (Materials Research Society, Pittsburgh, 1990), pp. 523-530.

8

D.P. Bentz and E.J. Garboczi, A digitized simulation model for microstructural development, in Advances in Cementitious Materials, ed. S. Mindess, Ceram. Trans. 16 (Amer. Ceram. Soc. , Westerville, Ohio, 1991), pp. 211-226.

9

D.P. Bentz and E.J. Garboczi, Simulation studies of the effects of mineral admixtures on the cement paste-aggregate interfacial zone, ACI Mat. J. 88, 518-529 (1991).

10

J.F. Young and W. Hansen, Volume relationships for CSH formation based on hydration stoichiometries, in Microstructural Development During Hydration of Cement, ed. L.J. Struble and P.W. Brown (Materials Research Society, Pittsburgh, 197), pp. 313-322.

11

G. Fagerlund, Frost resistance of concrete with porous aggregate, Report of the Cement and Concrete Institute of Sweden (1978).

12

E.J. Garboczi and D.P. Bentz, Digital simulation of the aggregate-cement paste interfacial zone in concrete, J. Mat. Res. 6, 196-201 (1991).

13

K. van Breugel, Simulation of Hydration and Formation of Structure in Hardening Cement-Based Materials, Ph.D. thesis, Dept. of Civil Engineering, Delft University of Technology, The Netherlands (1991).

14

K.L. Scrivener, A. Bentur, and P.L. Pratt, Quantitative characterization of the transition zone in high strength concretes, Adv. Cem. Res. 1, 230-237 (1988).

15

R.D. Hooton, Permeability and pore structure of cement pastes containing fly ash, slag, and silica fume, in Blended Cements, ed. G. Frohnsdorff (ASTM, Philadelphia, 1986), pp. 128-143.

16

E.E. Berry, R.T. Hemmings, W.S. Langley, and G.G. Carette, Beneficiated fly ash: Hydration, microstructure, and strength development in portland cement systems, in Fly Ash, Silica Fume, and Natural Pozzolans in Concrete, ed. V.M. Malhotra (Amer. Conc. Inst., Detroit, 1989), pp. 241-273.

17

M.H. Zhang and O.E. Gjorv, Microstructure of the interfacial zone between lightweight aggregate and cement paste, Cem. Conc. Res. 20, 610-618 (1990).

18

B. Ben-Othman and N.R. Buenfeld, Oxygen permeability of structural lightweight aggregate concrete, in Protection of Concrete (E. and F.N. Spon, London, 1990), pp. 725- 736.

19

R.L. Berger, Properties of concrete with cement clinker aggregate, Cem. Conc. Res. 4, 99-112 (1974).

20

D.P. Bentz, P.E. Stutzman, and E.J. Garboczi, Experimental and simulation studies of the interfacial zone in concrete, Cem. Conc. Res. 22, 891-902 (1992).