REFERENCES

[1] Standard Specification for Portland Cement, ASTM C 150-02, Annual Book of ASTM Standards, Vol. 4.01, 2001.

[2] R.H. Bogue, "Calculation of the Compounds in Portland Cement", PCA Fellowship Paper No. 21, October, 1929. Also − Industrial and Engineering Chemistry, Vol. 1, No. 4, P. 192, Oct 15, 1929.

[3] H.F.W. Taylor, Cement Chemistry, 2nd ed., Thomas Telford, 1997, 459 p.

[4] R.H. Bogue, The Chemistry of Portland Cement, 2nd ed., Reinhold Publishing, New York, 1955, 703 p.

[5] A.E. Moore, "Comparison of the results obtained for the compound composition of Portland cements by X-ray diffraction, microscopy, and wet chemical methods," Monograph No. 18, Soc. Chem. Ind., 331-361, 1964.

[6] L.P. Aldridge, 'Accuracy and precision of phase analysis in Portland cement by Bogue, microscopic, and X-ray diffraction methods,' and 'Accuracy and precision of an X-ray diffraction method for analyzing Portland cements,' Cem. Concr. Res. 12, 1982 p. 381-398, p. 437-446.

[7] L.J. Struble, "Cooperative Calibration and Analysis of Cement Clinker Phases, Report 2" Civil Engineering Studies, Structural Research Series No. 556, Dept. of Civil Engineering, University of Illinois at Urbana-Champaign, 21 pp., September, 1990.

[8] ASTM C 1365-98, "Standard Test Method for Determination of the Proportion of Phases in Portland Cement and Portland-Cement Clinker Using X-ray Powder Diffraction Analysis" Annual Book of ASTM Standards, Vol. 4.01, ASTM International, West Conshohocken, PA.

[9] P.E. Stutzman and S. Leigh, "Phase Composition Analysis of the NIST Reference Clinkers by Optical Microscopy and X-ray Powder Diffraction," NIST Technical Note 1441, 44 pp, September 2002.

[10] H. Möller, "Standardless quantitative phase analysis of Portland cement clinkers," World Cement, September 1995, pp. 75-83.

[11] P.M. Suherman, A. van Riessen, B. O'Connor, D. Bolton, and H. Fairhurst, "Determination of amorphous phase levels in Portland cement clinker", Powder Diffraction 17 (3), pp. 178-185, Sept. 2002.

[12] J.C. Taylor, Hinczak I, and Matulis, C.E., "Rietveld full-profile quantification of Portland cement clinker: The importance of including a full crystallography of the major phase polymorphs," Powder Diffraction 15, pp 7-18, March 2000.

[13] Form and Style for ASTM Standards, ASTM International, West Conshohocken, PA ASTM E177 − 86 "Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods"

[14] J. Mandel, Evaluation and Control of Measurements, New York: Marcel Dekker, 1991.